Electronic Products & Technology

Power Supply/Management

May 31, 2017 by Stephen Law

High input voltage dc-dc converters operate at high temperatures

ABSOPULSE  HHT 500-FX series of dc-dc converters are suitable for heavy-duty industrial applications that require high dc-input voltage at high operating temperatures. Units operate over a wide baseplate temperature range of -40°C to 85°C for full specification without the need…
May 30, 2017 by Stephen Law

Curtain to rise on EPTECH trade show in Vancouver

Trade show for members of electronics industry will be held at Molson Canadian Theatre on June 1st in Coquitlam BC - free attendance and free parking.
May 26, 2017 by Stephen Law

Water resistant mobile power module for healthcare  apps

BYTEC HEALTHCARE Geni-Tec battery power modules are fully submersible and have been tested to IP67 (NEMA6) rating  – resistant to dust and immersion in water of up to 1 meter. The IP rating or ingress protection classifies the degrees of…
May 22, 2017 by Stephen Law

Open frame pcb-mount power supplies are medically approved

BETADYNE NFM Series medically approved open frame printed circuit board mount power supplies provide 5W to 20W output power. Compact unit comes in 5W, 10W, 15W and 20W output power versions. The 2xMOPP medically approved products come in 85-265Vac input…
May 21, 2017 by Stephen Law

ICs enable 98% efficiency of power factor correction

POWER INTEGRATIONS HiperPFSTM-4 family of power factor correction (PFC) ICs serve applications targeting improved efficiency and power factor performance at both full load and light load conditions. Devices incorporate a 600V MOSFET suitable for 305Vac input and a high efficiency,…
May 17, 2017 by Stephen Law

Medical 35W triple output power supplies require no minimum loading

TDK-LAMBDA CUT35 low profile, triple output power supplies are packaged in the industry standard 2” x 4” footprint and requires no minimum load, simplifying installation. Operating from a universal input voltage of 85 to 265Vac, product is available in two…
May 17, 2017 by Stephen Law

3axis MEMS accelerometer boosts performance

MURATA SCA3300 series high performance 3 axis MEMS accelerometers measures 7.6 x 8.6 x 3.3mm and is suitable for a range of industrial and automotive applications. Small surface mount sensor provides several measurement ranges of 1.5, 3, or 6g and delivers lower than 10mg offset stability. Devices deliver…
May 15, 2017 by Stephen Law

Dc-dc converters boost I/O isolation, lower the RF impact

AIMTEC AM1DM-NZ and AM2DM-NZ series unregulated power supplies provide an extended momentary short circuit protection of 3 seconds and are built with reinforced insulation to achieve a high I/O isolation of either 6000Vdc or 4200Vac based on the application needs.…
May 12, 2017 by Stephen Law

Miniature resettable TCO devices protect battery cells

BOURNS Model SA series surface mount Miniature Resettable Thermal Cutoff (TCO) devices are resettable. Compatible with surface mount reflow soldering methods, devices are suitable overcurrent and overtemperature protection solutions for lithium polymer and prismatic cell battery packs. Devices can be…
May 10, 2017 by Stephen Law

Many head-turning innovations to display at Discovery

Hyperloop, smart homes, a personal helicopter, wearable technology, healthtech and cleantech among the advancements on display at Metro Convention Centre in Toronto next week
May 2, 2017 by Stephen Law

280W power supply is low profile, medically approved

FiDUS POWER VKL280 power dense series of open frame ac-dc power supplies come in a 3 x 5” package with an ultra-low 1.18” (30mm) profile. Devices provide a high convection cooled power rating of 210W, with 280W available when force cooled.…
April 26, 2017 by Stephen Law

Medical pcb type power supplies boost reliability

MEAN WELL RPS-400 Series of highly reliable, green, pcb type, medical power supply series consists of seven standard models with single outputs ranging from 12~48Vdc plus 5VSB @ 1A and 12V @ 500mA outputs. Unit is available in the standard…